Take-Up Housings

We’ve added Take-Up housing sizes from 1-15/16” to 3” for now and will add larger sizes later.

CXCT

https://www.crossocean.com/cxct/

CST

https://www.crossocean.com/cst/

This is feedback from Brazil.
Our CX2SN22-100 units have been running in chain mills for the last two years, while the competitor’s units last only one year.

4 Bolt Flange Type E Housings

We have added Type E 4-bolt flange housing sizes ranging from 2-7/16” to 4”. These additions were prompted by many requests from the US and some from other countries. They are slightly larger than standard 4-bolt flange housings, and we modified the design for easier identification.

CXC4EF

https://www.crossocean.com/cxc4ef/

CS4EF

https://www.crossocean.com/cs4ef/

CROSSLOC CX4SAF22-315L installed on a Centrifugal Fan.

They were impressed with how straightforward the locking collar was to use and also appreciated the QR code. The maintenance supervisor mentioned that after the fan was restarted, it hadn’t run this smoothly since it was new.

We have added an additional line to the laser marking instructions for the MOUNT on the CXC CLOSSLOC nut, as shown by the red arrow in the picture above.

When the shaft rotates rapidly counterclockwise, CXC CROSSLOC nuts are at increased risk of loosening and pulling the sleeve. For safety, ensure the setscrew is tightened firmly before use. The factory has not tightened it fully to avoid obstructing the shaft during installation.

https://www.brg2k.co.za/turning-the-tide-coc-bearings-enhance-performance-in-the-paper-pulp-sector/

The rusted black oxide nuts were replaced with zinc-nickel plated ones, which are highly resistant to rust.