What is the difference between CX and CXC？
CX insert bearings have CROSSLOC with standard adapter sleeves and the same outside diameter as 22200 series bearings. CX insert bearings fit only SN and SAF housings. They are one size larger than CS set screw lock and CXC CROSSLOC insert bearings.
CXC insert bearings have CROSSLOC with our original thin adapter sleeves and the same outside diameter as CS inserts. CXC and CS insert bearings fit only the S-2000 and Type E dimension housings.
I disassembled CROSSLOC. What is the gap between the nuts to reset?
CX CROSSLOC INSERTS
Use feeler gauges to set the clearance between inner and outer locking nuts of CX inserts. See below chart for those dimensions.
If the locking nuts become difficult to turn when tightening to the inner ring, make sure all cap screws are freed. The adapter sleeve should be at the inside edge of the chamfer of locknut. CX CROSSLOC pulls the adapter sleeve through the bore to lock the bearing to shaft
|CX||CAP SCREWS (metric)||NUTS CLEARANCE (mm)|
|22210CX-22215CX||M5 X 12 (Left hand)||0.5 (0, +0.4)|
|22216CX-22219CX||M6 X 14 (Left hand)||0.5 (0, +0.4)|
|22220CX-22232CX||M8 X 16 (Left hand)||0.8 (0, +0.5)|
CXC CROSSLOC INSERTS
The inner and outer locknuts should have a clearance of between 4.8 and 5.8mm depending on the size of the insert bearings. See the chart below for a list of those dimensions.
The adapter sleeve is usually flush with the outside locknut nut for the original starting position.
If the locking nuts become difficult to turn when tightening to the inner ring, make sure all cap screws are freed. CXC CROSSLOC pushes the adapter sleeve into the bore to lock bearing to shaft.
|CXC||CAP SCREWS (metric)||NUTS CLEARANCE (mm)|
|22208CXC-22215CXC||M5 X 12||4.8 (0, +0.2)|
|22216CXC-22219CXC||M6 X 14||5.3 (0, +0.2)|
|22220CXC-22222CXC||M8 X 16||5.8 (0, +0.2)|
What is the temperature range of SRB bearings?
The limiting factor is the NBR triple lip seal inside the bearing, which is rated from -20℃(-4°F) to +110℃(+230°F). The labyrinth seals without NBR lips can be used from -20℃(-4°F) to +160℃(+320°F), and up to +200℃(+392°F) for short period.