CX2SN17-075 (E)


1. Periksa semua tutup sekrup sudah di lepas.

2. Kencangkan tutup sekrup dengan pola bintang. Ulangi.

3. Saat menggunakan kunci momen, kencangkan setiap sekrup tutup ke nilai torsi yang sesuai di atas.

Note: The adapter sleeve needs to be pulled to lock and we use the left-hand cap screws to turn clockwise to pull. When you tighten the cap screws, the gap between two nuts gets bigger and the adapter sleeve is moving towards the outside. The outside nut should move parallel to the inside nut to avoid the cap screws twisting and getting damaged. This is why the cap screws are tightened in a star pattern and repeated. You may need to repeat this several times to tighten all the cap screws perfectly, this is a very standard way as seen with automobile wheels.


1. Longgarkan semua tutup sekrup hingga lepas.

2. Putar tutup sekrup berlawan arah jarum jam dengan pola bintang dan ulangi hingga lepas.

Note: When you want to unlock CROSSLOC™, loosening and turning counterclockwise is needed. They are the same left rotation but turning counterclockwise does not loosen. Loosen all cap screws to be freed first. Then you need to push the outside nut to release the adapter sleeve from the inner ring. Turn the cap screws counterclockwise in a star pattern and repeat until dismounted. It’s same as locking and the outside nut should move parallelly.

Recommended Shaft Tolerance : -0.004 in. / -0.102 mm

When the shaft is smaller than above, you can try below.

1. Loosen the CROSSLOC™ two nut locking system and take off from the unit. (Take care not to change the clearance between the nuts.)

2. Push the adapter sleeve from the back of bearing by hitting with the driver and hammer.

3. Make sure the shaft can slide through the bore of bearing easily.

4. Put the CROSSLOC™ two nut locking system back on the bearing. When two nut system won't rotate any further, hit with the driver and hammer to turn and tighten.

Speed Limits (rpm)

Recommended Number of Months Between Relubrication

(Based on Operating Speed (rpm) and Continuous Operations)